I have tryed every method for pointing and this is the best way. Easyjoint patio grout review.
Then pour four buckets of sand into the mixer to produce standard patio mortar mix or three buckets for a patio pointing mix.
Patio pointing mix. Use withe cement 3 part sand one cement no to wet mix all by hand or mashine and put very little water brush in with brush push down with piece of pipe or hose or buy the pointing ready made which is resin can be applied even if the paving is wet get very harde. Pour your compound product over the patio use a good quality jointing compound like marshalls weatherpoint 365 to achieve an attractive finish on your patio. Pour half a bucket of clean water into the mixer.
I have found the best mix for pointing any slabs is 2 sharp sand 2 building sand and 1 cement with 2 capfulls of pva neat i use febond. This method is aimed squarely at diyers using cheap readily available materials. This is more commonly called playpit sand.
Yes pointing is the word for filling in the joints. Make sure you do not put too much water in or you will stain the slabs. Mix up sand and cement dry and when ready to put water in add the pva.
The cost of materi. Do not mix on the patio. Pointing of all kinds should be carried out on a dry day and when your patio itself is dry.
Plus with a mortar jointing product staining can occur on your patio flagstones. The sand is mixed with cement at a ratio of 1 to 1 and spread out to dry thoroughly. The better contractors will use a pointing bar or the blade of a trowel to press down the dry mix compacting it into the joint and then brushing in additional mix repeating this sequence until all the joints are properly filled.
For joints which are less than an inch 13mm you should use silver sand. How to point a patio. This will save you time on the job compared to simple mortar which can t be used in wet weather.
The easyjoint patio grout is the best brush in patio grout on the market. This product can be used in all weathers simply requiring water to wash and fill the joints. If applicable add the plasticiser according to the instructions on the packaging.
For both mixes add one bucket of cement. It s very easy to apply entering the joints between paving materials to provide an aesthetic and effective finish. I m well aware that quicker more expensive compounds are available to pro.
Then you can start to point in.